D24T.com

D24T.com (http://d24t.com/index.php)
-   Suspension and Brakes (http://d24t.com/forumdisplay.php?f=5)
-   -   Front end wanders, clunks (http://d24t.com/showthread.php?t=265)

ngoma 02-16-2010 09:30 AM

Front end wanders, clunks
 
1985 740 GLE d24t, 174,xxx miles.

Car likes to wander and clunks pretty good sometimes on low speed bumps. Also RF wheel looks like it has too much negative camber (wheel tilts inward at top).

Lifted the front end and checked bushings w/ a prybar and didn't see any obvious loose connections. Wheel bearings felt solid. Is there a special way to test the ball joints and struts? Is there a way to test the strut top bushings?

RLDSL 04-01-2010 02:54 PM

If it's wandering, clunking and tilting inward at the top, you've already answered your own question, that top strut bearing is toast. FCP groton has them here about $35

piper109 08-15-2010 07:58 AM

Might I suggest also that you go to www.brickboard.com and find the 700/900 FAQ and read the pertinent sections. There is a wealth of experience and vehicle help on there with stuff which is not engine dependent.

Steve

RedArrow 05-02-2013 07:02 PM

Signs of bad ball joints/struts/bearings/wheel bearings?
 
Is there a special way to test the ball joints and struts? Is there a way to test the strut top bushings?[/QUOTE]

Yes, that would be useful to know about. I`m also having somethings going on :) at low speed bumps only, especially at slow turns but mostly when driving through uneven/ bumpy road surfaces. Diagnosis:
A,suddenly some oil visible on/under the front (left side) shock
B,left front clunks and I also hear some metal on metal noise sometimes while driving through bad roads.... that can sound like pennies in a beer can if shaken... OR... like 2 loose metal rings shaken on a metal rod or something similar to that.
C,if I push car down many times, I do hear a click-clunk every single time.
D,there`s no bad noise while turning wheel side to side. (strut bearing ok?)
E,front bushings are in ok condition

How does a very bad ball joint sound or behave? Although I do think it`s my strut that went up to heaven but I was scared to compress these strong King Kong springs with a sh!tty cheap compressor especially with manual tools. (Michaelovitch did it on his Renault smoothly but currently I do not have a great spring compressor. I am also hesitating on what type of struts needed/suggested. I think I have the front springs of the Diesel donor vehicle that was used to build this originally gasser wagon. etc etc)

ngoma 05-02-2013 09:51 PM

Quote:

Originally Posted by RedArrow (Post 6863)
Is there a special way to test the ball joints and struts? Is there a way to test the strut top bushings?

Might have better results for questions on standard Volvo issues non-specific to D24 on some of the other (MUCH more active, MUCH larger pool of knowledgable responders, etc.) Volvo RWD forums. Here are three:

http://www.brickboard.com/RWD/index.htm?model=700
also look at their 700-series FAQ

http://forums.turbobricks.com/forumd...oto_forumtools

volvoforums.com/forum/volvo-240-740-940-12/

Quote:

Originally Posted by RedArrow (Post 6863)
suddenly some oil visible on/under the front (left side) shock

Oil leaks from shocks/struts are bad news. I replace them when I see oil.

Quote:

Originally Posted by RedArrow (Post 6863)
left front clunks and I also hear some metal on metal noise sometimes while driving through bad roads.... that can sound like pennies in a beer can if shaken... OR... like 2 loose metal rings shaken on a metal rod or something similar to that.

Strut top bushings will give a clonk mostly when driving up a driveway apron at an acute steering angle.

Quote:

Originally Posted by RedArrow (Post 6863)
How does a very bad ball joint sound or behave?

Mine started erratic wandering, a vague feeling of steering instability. It was hard to verify. I had the front end supported on jack stands to replace the diagonal strut rod cone bushings and accidentally saw the two halves of the balljoint move independent of each other only when the wheel was pointed in a certain direction and moved along a specific axis. Otherwise, it tested OK. Don't recall any noticeable noise.

Quote:

Originally Posted by RedArrow (Post 6863)
I am also hesitating on what type of struts needed/suggested.

Folks are saying the Bilstein HD are a bit to hard for daily driver, forget if they liked Monroe or Gabriel (or KYB?) or OEM Sachs/Boge. Think it was Sachs/Boge.

745 TurboGreasel 05-03-2013 01:20 PM

Sometimes on install the strut tubes are back filled with mineral oil for more heat disipation, if that is leaking, no big deal.

v8volvo 05-05-2013 09:39 PM

If the strut is leaking oil then you won't have much damping on that corner, are you noticing ride/handling symptoms too or only noises? Most of that stuff I put on new and should not be breaking down yet. Struts maybe since they've seen a lot of miles already but balljoints for sure should be fine....

It does have the diesel front springs but the strut inserts are all the same either way.

As for the noises, have you checked to see if the big gland nut that holds the shock insert into the strut tube is tight? Sometimes those will loosen up and make bad noises as the shock jumps up and down inside the tube...

RedArrow 05-07-2013 07:26 PM

Sounds of a bad strut I guess
 
Quote:

Originally Posted by v8volvo (Post 6897)
If the strut is leaking oil then you won't have much damping on that corner, are you noticing ride/handling symptoms too or only noises? Most of that stuff I put on new and should not be breaking down yet. Struts maybe since they've seen a lot of miles already but balljoints for sure should be fine....

It does have the diesel front springs but the strut inserts are all the same either way.

As for the noises, have you checked to see if the big gland nut that holds the shock insert into the strut tube is tight? Sometimes those will loosen up and make bad noises as the shock jumps up and down inside the tube...

Well, i`m not absolutely 100% sure that the oil is from the strut tube (might be some brake fluid seeping from the caliper) but I am definitely sure that the left front of the car has some kind of a suspension issue that I can clearly experience&hear .all times. + it also feels through the steering wheel as well... when I hit small bumps or while driving through uneven surfaces the left front has that knock/knock/clunk sound to it. Easy to hear a `keychain-type` noise as well, like there were metal rings loose being shaken on a metal rod. On the other hand the car cruises straight, steering feels pretty stable and tight and there are no badly deformed bushings or loose connections anywhere at the front. Most of the clunking noises (L side only) occur on low speed bumps and slow turns but the major knocking sound comes if the wheel arrives in a hole or on a larger bump. Then it sounds like I drove through a deep manhole that has a sloppy loose lid or whatever and it produces a sound of a shaky metal hit on metal sound effect...

I think it has something to do with the strut itself, idk. The insert probably has too much play inside & it moves around in the tube.
If I grab the wheel on top and pull on it hard, I think I can see the strut insert being in a slightly angled position; it has an unwanted movement too with a sound somewhere inside.
Yes, I think the ball joints and tie rod ends are all fine but we`ll inspect them again next time at the removal of this crazy strut.
I noticed a knocking/clicking sound btw many-many thousands of miles ago but that time it happened only at very slow speeds and only at left turns on very bumpy roads. I suspected the upper strut mount and bearing that time. We talked about it, remember and it seemed okay but I suspected that it will end up being more sensitive over there. :) I just kept hearing that sound but there were no negative effects on handling. In Jackson Hole, WY I showed it to a European car specialist :) mechanic who said that my strut is going to be toast soon but it`s completely fine to keep driving. 10k later I`m here but whatever it is, will be solved I`m sure.
I will keep the d24t pros` good advice on which spring compressor to buy. Thanks for now!
Low quality video: http://www.youtube.com/watch?v=FAuYG...ature=youtu.be
http://www.youtube.com/watch?v=BPQ5e...ature=youtu.be

RedArrow 05-08-2013 08:34 PM

Quote:

Originally Posted by v8volvo (Post 6897)

As for the noises, have you checked to see if the big gland nut that holds the shock insert into the strut tube is tight? Sometimes those will loosen up and make bad noises as the shock jumps up and down inside the tube...

Tomorrow I will, thanks!

745 TurboGreasel 05-08-2013 11:28 PM

Yes, mine sounded like that after it came loose while riding on a flatbed tow truck:confused:Reached in with a big pliers, and cranked it back down, worked fine till I got some fancier struts.


All times are GMT -8. The time now is 05:25 AM.

Powered by vBulletin® Version 3.8.10
Copyright ©2000 - 2024, vBulletin Solutions, Inc.