jpliddy
07-16-2016, 09:27 AM
hi all i have just adjusted the rev tickover on my 940 tdi auto 1995 to just over 900 revs can this cause any problems i did this by adjusting the slide pin with the ball end pin with the nut underneath.
engine runs a little higher at col start too now but soon drops back to 900 plus revs.
reason i have done this it stops my alternator belt from bouncing so much that the life of the belt is shortened so much and teeth start to come of the belt .
its been doing this for a long time so thought i would try try to fix it .
i only moved this pin bout 4 mm .
any comments most welcome
engine runs a little higher at col start too now but soon drops back to 900 plus revs.
reason i have done this it stops my alternator belt from bouncing so much that the life of the belt is shortened so much and teeth start to come of the belt .
its been doing this for a long time so thought i would try try to fix it .
i only moved this pin bout 4 mm .
any comments most welcome